SS Engineers & Consultants

Milk Chilling Unit

by SS Engineers & Consultants

Milk Chilling Plant

The SS Engineer’s milk cooling system represents the best milk cooling system for your farm, milk collection center or for your milk processing house.

INTRODUCTION

Chilling of milk means rapid cooling of raw milk to a sufficiently low temperature so that the growth of micro-organisms present in milk is retarded. In the chilling process, the temperature of the milk should be reduced to 4° Celsius.

PURPOSE OF CHILLING

At the farm, if the farmer has no provision to cool the milk after obtaining from the udder of the milch cattle, it should be delivered to the nearest milk chilling center with (in 2-3hours), where the milk is chilled immediately to 4o centigrade and stored in a milk storage tank which is insulated.

PROCESS OF CHILLING UNIT

In the refrigeration system (IB) chilled water is prepared at 0.5o-1o centigrade, and is pumped through a tubular pre-cooling or heat plate exchanger, in counter-current with the milk from the raw milk tank to reduce the temperature of the milk from 35o-4o centigrade.

Advantages of ice water milk cooling system in comparison with a traditional system:

1. Milk gets chilled through the raw milk chiller instantaneously.

2. There is a provision to Re-chill the milk whenever the milk temperature in the milk storage tank is increased over and above 6-8 centigrade.

3. IBT has the provision of ICE thick controller and chilled water agitator to dissolve Ice.

4. An environmentally friendly milk storage tank is insulation with PUF.

5. Higher cooling performance with an automatic expansion of refrigerant in the IBT.

6. Milk is immediately cooled below the critical limit of 10° with ice water, stopping immediately the bacterial growth.

7. Mixing low temperature during on-goings milking reduces drastically the possibility of bacterial growth

8. Milk can be collected anytime even during the milking phase when cooled immediately.

9. It is possible to cool small quantities of milk without any freezing risk.

10. It allows power management for cooling at different times compared to the milking phase.

11. The ice can be rebuilt through the use of smaller compressors. The electric request is therefore lower.

Integrated products:

Glycol Milk Chiller Refrigerator Cooling System, Water chilling unit milk fast cooling system, Integrated Industrial Cooling System Water Chiller for Milk Cooling Machine Filling Line, Milk Cooling System Glycol Water Chiller with Heat Recovery.

Applications:

Dairy farms, Milk Collection center, Milk Processing Plant, Milk vending tanker, Milk parlors, thermal cooling system for liquid food products.

Machinery Industry:

SS Engineer's chiller can cool down the oil for the machine and stabilize the oil temperature and pressure. It'll extend the useful life of the oil. And it can also improve mechanical lubrication efficiency.

Food & Drink Processing Industry:

The temperature of processed food and drink will be too high to be packaged. SS Engineers chiller can cool it down through a food-grade stainless steel heat exchanger.

Milk Chilling Plant Module

Whole system compact size and semi/ fully automatic controlled, this system can auto-adjust the flow rate and working compressors.
Processing capacity ranges from 500L to 8,000L/H

Water Chiller Module

Main Features:
1. Apply for advanced Europe and America fully-closed low-noise, high-efficient screw compressor, imported digital thermostat.
2. Unit with stainless steel water tank and large flow, high head HAYE dedicated water pump.
3. The temperature of leaving water can be controlled within more than -5°C.
4. HYS-WD serial unit with two refrigerating loop circuit, which can interchangeably and independently run.
5. Perfect safety protection system and failure electronic signal assure that unit operates without damage or run safely.
6. Running in a high automatization and intellectualization, no pollution.
7. The units are started in stages to reduce the impact on power.